Bitmain Antminer S21e Hyd (338Th)

AsicProfit Support AsicProfit · 27 окт. 2026 г.

Bitmain allows antifreeze, pure water or deionized water. Keep the pH in range for the coolant you use: antifreeze 7.0 to 9.0, pure water 6.5 to 7.5, deionized water 8.5 to 9.5. Never use tap water. If the pipes turn yellow or the water quality drops, Bitmain says to shut the miner down and change the coolant. Flow should stay at 8 to 10 L/min, under 3.5 bar.

AsicProfit Support AsicProfit · 25 окт. 2026 г.

They are hashrate bins of the same water-cooled S21e Hyd at about 17 J/TH. Bitmain lists 288 TH/s at 4896 W and 310 TH/s at 5270 W, measured at a 35 C coolant inlet. Higher bins earn more per unit but draw proportionally more power. All versions need the same three-phase supply and water loop, so the choice comes down to price per TH. The calculator above helps compare them.

AsicProfit Support AsicProfit · 22 окт. 2026 г.

The power supply is built in, but Bitmain lists the S21e Hyd cord as not included. You need a three-phase 380 to 415 V connection, 50 to 60 Hz, with a maximum of 12 A per phase. Get it wired by an electrician who knows three-phase work. Wrong wiring can stop the boards from starting or damage the power supply, as one hydro owner found.

AsicProfit Support AsicProfit · 2 окт. 2026 г.

Drain it completely. Bitmain says to blow the remaining liquid out of the cold plates with an air pump, then cap the inlet and outlet. Water left inside can freeze and crack the plates or connectors, or leak onto the hashboards. Bitmain warns that both can void the warranty. Warranty is 365 days from shipping for the original buyer from Bitmain.

AsicProfit Support AsicProfit · 17 сент. 2026 г.

Bitmain's hydro troubleshooting guide groups faults by the indicator lights. A red light with high temperature usually means the coolant valves are closed or the water temperature is out of range, so check that the inlet and outlet valves are open and the inlet is between 20 and 50 C. If the miner has no IP address, check the cable and switch, then reset it. The kernel log shows which board or sensor failed.

AsicProfit Support AsicProfit · 14 сент. 2026 г.

People do use hydro miners for heat. Do not pump pool or heating-system water straight through the miner, because the chemicals can corrode its aluminium cold plates. Owners on Bitcointalk use a stainless-steel plate heat exchanger, with clean coolant on the miner side. Keep the miner's inlet between 20 and 50 C and control the temperature so it does not swing widely. Check local rules for electrical and plumbing work.