Máy tính từ widget miễn phí của chúng tôi: mọi thời gian hoàn vốn trên trang này đều tính theo nó.
Thu nhập mỗi ngày
$6.87
Tiền điện mỗi ngày
−$2.87
Hosting mỗi ngày
—
Lợi nhuận mỗi ngày
$4.00
Hoàn vốn ở giá $1,111
—
Lợi nhuận và thời gian hoàn vốn là ước tính dựa trên giá coin và độ khó mạng hôm nay, chưa trừ phí pool, hosting và thuế. Chúng thay đổi mỗi ngày. Không phải lời khuyên tài chính.
Bảng xếp hạng dùng coin chính của thuật toán (BTC cho SHA-256, LTC + DOGE cho Scrypt): các chuỗi phụ nhỏ hôm nay có thể trả nhiều hơn trên mỗi hash nhưng không hấp thụ được nhiều hashrate.
Bitmain Antminer S21 (188Th) là máy đào ASIC của Bitmain cho thuật toán SHA-256, đạt 188 TH/s với 3,290 W. Máy ra mắt vào tháng 2 năm 2024. Với 17.5 J/TH, máy hiệu quả hơn 14% so với mức trung vị của các máy SHA-256 chúng tôi theo dõi (20.4 J/TH). Với giá điện $0.036/kWh, máy xếp thứ 120 trong 299 máy SHA-256 theo lợi nhuận ngày, kiếm khoảng $4.00 mỗi ngày khi đào BTC. Giá tốt nhất trên AsicProfit là $1,111. Theo số liệu hôm nay, máy sẽ hoàn vốn trong khoảng 278 ngày. Với 75 dB, máy nên đặt ở khu đào chuyên dụng hoặc trung tâm hosting.
Hỏi và đáp 6
Hỏi về máy đào này. Tài khoản đã xác minh có thể hỏi và trả lời, người bán trả lời với tư cách cửa hàng, và mọi bài viết đều được kiểm tra trước khi hiển thị.
Chen L. · 23 thg 10, 2026 · về phiên bản khác
How hot can my garage get before the S21 starts throttling?
AsicProfit SupportAsicProfit · 24 thg 10, 2026
Bitmain rates the air S21 for 0 to 45°C intake air, higher than the S19 series. In tests, stock firmware ran at full spec at 10 and 20°C and began underclocking near 40°C. Above 900 m altitude the limit drops 1°C per 300 m.
Janis O. · 22 thg 10, 2026 · về phiên bản khác
My S21 stops hashing after a few minutes and shows a board error, any ideas?
AsicProfit SupportAsicProfit · 23 thg 10, 2026
Read the kernel log first. Common causes are a hashboard knocked loose in shipping, a bad data cable or an unstable power supply. One owner fixed this by replacing a faulty supply cable. Reseat cables and test boards one at a time. If it is under Bitmain's 365 day warranty, open a repair ticket rather than opening the case.
Dmitri V. · 20 thg 10, 2026 · về phiên bản khác
S21 immersion, what oil temperature and flow does it need?
AsicProfit SupportAsicProfit · 22 thg 10, 2026
Bitmain lists the S21 Imm at 239 TH/s and 3,824 W in normal mode or 301 TH/s and 5,569 W in high mode, with inlet oil at 30 to 55°C and about 1 cubic metre per hour of coolant flow. It runs on three phase 380 to 415 V. High mode is less efficient.
Felix W. · 3 thg 10, 2026 · về phiên bản khác
What does the S21 Hyd need for cooling and power?
AsicProfit SupportAsicProfit · 5 thg 10, 2026
The S21 Hyd makes about 335 TH/s at 5,360 W on three phase 380 to 415 V. It needs 8 to 10 L/min of deionized or pure water per unit, pressure up to 3.5 bar, pH 8.5 to 9.5, DN10 connectors, and inlet water up to 35°C in normal mode. Replace coolant once conductivity reaches 100 microsiemens per cm.
Oleh B. · 28 thg 9, 2026 · về phiên bản khác
what plug does the S21 come with, C19 or C20?
AsicProfit SupportAsicProfit · 29 thg 9, 2026
Bitmain lists a P33 to P13 or C20 to P13 cord included with the air cooled S21. The P13 end goes into the miner's power supply; the C20 end plugs into a C19 socket on a PDU. Hyd and immersion versions use different power supplies, and the Hyd cord is not included.
Minjun P. · 16 thg 9, 2026 · về phiên bản khác
Will an S21 run on a 16A circuit?
AsicProfit SupportAsicProfit · 17 thg 9, 2026
It is too tight. Bitmain lists about 3,500 W at the wall for the 200 TH/s air S21, on 220 to 277 V with up to 20 A on one input wire. At 230 V that is over 15 A continuously, which leaves no margin on a 16 A breaker. Give it a dedicated 20 A or larger circuit sized by an electrician.
Đăng nhập bằng tài khoản đã xác minh để đặt câu hỏi. Đăng nhập