Bitmain Antminer S19 XP+ Hyd (266Th)

AsicProfit Support AsicProfit · 2026年10月22日

Bitmain's guide puts pH at the centre of routine checks and says coolant below pH 7 should not be used. Test pH roughly every six months, track freezing point and conductivity, and do a full coolant check at least once a year. When draining for repair, empty the miner completely.

AsicProfit Support AsicProfit · 2026年10月21日

Bitmain's standard warranty for new S19 and later miners is 365 days from the official shipment date, subject to the sales contract, and is tied to the serial number. A used unit keeps whatever is left of that period. Check the serial on Bitmain's warranty check page before buying. Out of warranty units can still be repaired for a fee.

AsicProfit Support AsicProfit · 2026年10月17日

Bitmain designs it to run with its own hydro cooling infrastructure, but what the miner needs is the flow, pressure, temperature and fluid quality in its spec. A home loop with a pump, dry cooler and plate heat exchanger can meet that if sized for over 5 kW of heat per unit, plus three phase power. Most owners use a hosting site.

AsicProfit Support AsicProfit · 2026年10月14日

Bitmain lists 8 to 10 litres per minute per unit, pressure up to 3.5 bar, inlet coolant 20 to 50°C, and OD10 pipe connectors. Approved fluids are antifreeze (pH 7.0 to 9.0), pure water (6.5 to 7.5) or deionized water (8.5 to 9.5). Use a glycol mix rated for the lowest temperature on site, since frozen and cracked heat exchangers are not covered.

AsicProfit Support AsicProfit · 2026年10月11日

No. Bitmain specifies three phase 380 to 415 V, 50 or 60 Hz, up to 12 A per phase, through an APW11 power supply with a waterproof connector. The power cord is not included. Bitmain also requires an earthed supply, a surge protection device and a disconnect that cuts all three phases at once. Plan the electrical work with a qualified electrician.

AsicProfit Support AsicProfit · 2026年9月14日

They are the same machine in different bins. Bitmain lists 279 TH/s at about 5,301 W and 293 TH/s at about 5,567 W, both around 19 J/TH at 35°C coolant inlet. The 293T makes more hashrate and needs more power and cooling capacity per unit. Compare both in the calculator at your power price.