تعتمد التصنيفات على العملة الرئيسية للخوارزمية (BTC لـ SHA-256، وLTC + DOGE لـ Scrypt): قد تدفع السلاسل الجانبية الصغيرة أكثر لكل hash اليوم، لكنها لا تستوعب الكثير من معدل التجزئة.
Bitmain Antminer S21 (175Th) جهاز تعدين ASIC من Bitmain لخوارزمية SHA-256، بقدرة 175 TH/s واستهلاك 3,107 واط. صدر في فبراير 2024. بكفاءة 17.8 J/TH يتفوق بنسبة 13% على الجهاز الوسيط لخوارزمية SHA-256 لدينا (20.4 J/TH). بسعر $0.036/كيلوواط ساعة يحتل المرتبة 126 من 299 أجهزة SHA-256 حسب الربح اليومي، ويكسب نحو $3.69 يوميًا من تعدين BTC. أفضل سعر على AsicProfit هو $1,099. بالأسعار الحالية يسترد ثمنه خلال نحو 299 يومًا. بمستوى 75 ديسيبل مكانه موقع تعدين مخصص أو منشأة استضافة.
أسئلة وأجوبة 6
اسأل عن جهاز التعدين هذا. الحسابات الموثّقة تسأل وتجيب، والبائعون يجيبون باسم متاجرهم، وتتم مراجعة كل مشاركة قبل ظهورها.
Chen L. · 23 أكتوبر 2026 · عن إصدار آخر
How hot can my garage get before the S21 starts throttling?
AsicProfit SupportAsicProfit · 24 أكتوبر 2026
Bitmain rates the air S21 for 0 to 45°C intake air, higher than the S19 series. In tests, stock firmware ran at full spec at 10 and 20°C and began underclocking near 40°C. Above 900 m altitude the limit drops 1°C per 300 m.
Janis O. · 22 أكتوبر 2026 · عن إصدار آخر
My S21 stops hashing after a few minutes and shows a board error, any ideas?
AsicProfit SupportAsicProfit · 23 أكتوبر 2026
Read the kernel log first. Common causes are a hashboard knocked loose in shipping, a bad data cable or an unstable power supply. One owner fixed this by replacing a faulty supply cable. Reseat cables and test boards one at a time. If it is under Bitmain's 365 day warranty, open a repair ticket rather than opening the case.
Dmitri V. · 20 أكتوبر 2026 · عن إصدار آخر
S21 immersion, what oil temperature and flow does it need?
AsicProfit SupportAsicProfit · 22 أكتوبر 2026
Bitmain lists the S21 Imm at 239 TH/s and 3,824 W in normal mode or 301 TH/s and 5,569 W in high mode, with inlet oil at 30 to 55°C and about 1 cubic metre per hour of coolant flow. It runs on three phase 380 to 415 V. High mode is less efficient.
Felix W. · 3 أكتوبر 2026 · عن إصدار آخر
What does the S21 Hyd need for cooling and power?
AsicProfit SupportAsicProfit · 5 أكتوبر 2026
The S21 Hyd makes about 335 TH/s at 5,360 W on three phase 380 to 415 V. It needs 8 to 10 L/min of deionized or pure water per unit, pressure up to 3.5 bar, pH 8.5 to 9.5, DN10 connectors, and inlet water up to 35°C in normal mode. Replace coolant once conductivity reaches 100 microsiemens per cm.
Oleh B. · 28 سبتمبر 2026 · عن إصدار آخر
what plug does the S21 come with, C19 or C20?
AsicProfit SupportAsicProfit · 29 سبتمبر 2026
Bitmain lists a P33 to P13 or C20 to P13 cord included with the air cooled S21. The P13 end goes into the miner's power supply; the C20 end plugs into a C19 socket on a PDU. Hyd and immersion versions use different power supplies, and the Hyd cord is not included.
Minjun P. · 16 سبتمبر 2026 · عن إصدار آخر
Will an S21 run on a 16A circuit?
AsicProfit SupportAsicProfit · 17 سبتمبر 2026
It is too tight. Bitmain lists about 3,500 W at the wall for the 200 TH/s air S21, on 220 to 277 V with up to 20 A on one input wire. At 230 V that is over 15 A continuously, which leaves no margin on a 16 A breaker. Give it a dedicated 20 A or larger circuit sized by an electrician.