PCPraha주목✓ 인증된 판매자Secret easter egg: $50 off, if you dig연장 보증재고 보유, 빠른 배송Antminer S23e Hyd 2U · 865 TH/s / Batch listopad 2026 / Doma$0.0368/kWh부터, 월 $232에 호스팅Czechia에서 발송 · 9시간 전 확인
오늘의 코인 가격과 네트워크 난이도 기준 추정치로, 위의 풀 수수료·가동률·호스팅 반영 후 세전 금액입니다. 투자 조언이 아닙니다.
수익 · 전기 요금 $0.0364/kWh
$0.036/kWh 기준 Bitmain Antminer S23e Hyd 2U (865Th)은(는) 일일 수익으로 299대의 SHA-256 채굴기 중 4위이며, BTC 채굴로 하루 약 $17.01를 법니다. AsicProfit 최저가는 $9,212입니다. 현재 수치로는 약 542일 만에 본전을 찾습니다. 기준 수치, 15분마다 업데이트됩니다.
이 채굴기에 대해 질문하세요. 인증된 계정이 질문하고 답하며, 판매자는 매장 이름으로 답합니다. 모든 글은 확인 후 게시됩니다.
Ryan M. · 2026년 10월 26일
What exact power does the S23e U2H take? 3-phase only?
AsicProfit SupportAsicProfit · 2026년 10월 26일
Yes, three-phase only. Bitmain gives an AC input range of 342 to 528 V, a rated range of 380 to 480 V at 50 to 60 Hz, a maximum input current of 20 A and an LP34 power port. Typical draw is 8650 W at a 35 C coolant inlet. Wrong input voltage can damage the server, so have the electrical side done by a qualified electrician.
Petr S. · 2026년 10월 16일
What coolant flow, temperature and pH does the S23e Hyd need?
AsicProfit SupportAsicProfit · 2026년 10월 17일
Bitmain lists inlet coolant at 20 to 50 C (35 C typical), flow of 16 to 20 L/min, and pressure up to 3.5 bar. You can use antifreeze, deionized water or pure water, with pH targets of 7.0 to 9.0 for antifreeze, 8.5 to 9.5 for deionized water and 6.5 to 7.5 for pure water. The pipe connector is UQD08. Keep the loop clean and filtered.
Oleh B. · 2026년 9월 29일
How long is the warranty on the S23e Hyd 2U compared to air-cooled Antminers?
AsicProfit SupportAsicProfit · 2026년 9월 30일
Bitmain lists a 365-day warranty from the shipping date for the S23e U2H, longer than the 180 days it gives on several air-cooled models such as the KS7. The warranty applies to the original buyer who purchased directly from Bitmain. If you buy through a reseller, the reseller handles warranty, so get their terms in writing.
Anna S. · 2026년 9월 19일
Will a 2U S23e fit in a normal server rack?
AsicProfit SupportAsicProfit · 2026년 9월 20일
It is a 2U rack unit at 600 x 482.6 x 86 mm without packaging, so it fits standard 19 inch rack width, but you need enough depth for the chassis plus coolant connections and the power cable. Each unit weighs roughly 28 to 31 kg, so check your rack's load rating and use proper rails. Bitmain also sells racks and containers designed for these 2U hydro units.
Gabor N. · 2026년 9월 16일
Can I run an S23e Hyd 2U at home or is it strictly for data centers?
AsicProfit SupportAsicProfit · 2026년 9월 17일
It is built for racks and liquid-cooling infrastructure. Bitmain specifies three-phase power with a rated range of 380 to 480 V, about 8650 W per unit, and a coolant loop with 16 to 20 L/min of flow. Bitmain points to its container and dry-cooling tower manual for coolant handling. A home build is possible only with three-phase supply, a pump, heat exchanger and plumbing, so most buyers host it.
Jake T. · 2026년 9월 15일
Anything special about storing or shipping an S23e Hyd between sites?
AsicProfit SupportAsicProfit · 2026년 9월 16일
Yes. Bitmain warns that the server must be stored completely dry, with no coolant or water left inside, because residual liquid can cause corrosion, short circuits and permanent damage. Drain and dry the unit before storage or transport. Bitmain lists a storage temperature of -40 to 85 C and operating humidity of 10 to 90 percent, non-condensing.